Product code: 100005675
Manufacture`s article: 0000o5690
Water-based bituminous emulsion Izoplast R-W, 10 l ADW
Bitumen anionic emulsion Izoplast R-W is designed for priming the surface and performing "light" waterproofing before laying rolled and liquid waterproofing materials (Izoplast B-W, Izoplast 2K-W) on any mineral surfaces, as well as for protecting wooden elements.
Advantages of the material:
- Ready for use
- Does not contain solvents
- Can be applied to dry and wet surfaces
- Dries quickly
- Penetrates deeply into the base
- Enhances the adhesion of the base to insulating materials
- Protects the base from the effects of weather conditions
- Protects the bases from the effects of chemicals and salts
- It can be used in contact with expanded polystyrene, mineral wool and wood
Application areas:
- To create moisture- and water-proof insulation coatings on vertical and horizontal concrete surfaces
- In private construction and in large-scale infrastructure facilities
- To protect wooden products and elements (poles, fences) from moisture
- To create a thin layer of waterproofing
Surface preparation:
To create a reliable insulating coating, the surface must be smooth, without bumps, depressions and cracks. If there are voids and/or cracks on the surface, they must be repaired with appropriate repair compounds.
Before applying the material, the surface must be cleaned of dirt, dust, oils and other substances that interfere with adhesion. It is necessary to use Izoplast R-W on fresh concrete surfaces after the end of the concrete drying period.
Preparation of the material:
Mix the material thoroughly before use.
To be used as a primer, Izoplast R-W must be diluted with clean water in a ratio of 1:1.
Application of the material:
IZOPLAST R-W is applied with a roofing brush or a brush with stiff bristles. Each next layer must be applied after the previous one has completely dried. The drying time depends on the temperature and humidity of the environment and the substrate (up to 6 hours).
Recommendations for use, storage and transportation:
Store and transport at a temperature not lower than +5°C.
The tool after use with IZOPLAST R-W should be washed with water immediately after use, after drying it can only be cleaned mechanically.
|
Composition |
Water-based bitumen emulsion |
|
Colour |
Black |
|
Packaging |
Bucket 10 l |
|
Full drying time |
10 days |
|
Time between application of layers |
6 hours |
|
Consumption (priming and first layer) |
0.2 - 0.5 l/m2 |
|
Consumption (next layers) |
0.15 - 0.35 l/m2 |
|
Application temperature |
from +5°C to +30 °C |
Other products in the category
External waterstop ND 320 PVC for expansion joints, blue, 20 lm, Sanpol Ukraine
Useful articles
