Product code: 100005211
Manufacturer's article: 0000o5688
Bitumen-rubber mastic on Izoplast B solvent, 24 kg ADW
Izoplast B is a bitumen mastic with special additives and high penetrating properties, based on an organic solvent. To create highly resistant waterproofing coatings.
Application:
- Waterproofing of pipes and sewer wells, concrete rings, pumping stations
- Waterproofing of concrete foundations — foundations, screeds, fences, columns and supports
- Seamless waterproofing of vertical and horizontal surfaces
- Waterproofing with high resistance to aggressive environment
- Roof preservation and waterproofing
Advantages:
- Easy to use
- Covers all microcracks in the base
- For industrial and residential construction
- For roofing of any slope
- Resistance to weak acids and salts
Instructions for use:
Mix before use. Apply the mass with a roofing brush or brush. Apply the next layer after the previous one has completely dried. The waiting time before laying the second layer of IZOPLAST B waterproofing compound is about 8 hours. To increase the adhesion of the material to the surface, use IZOPLAST R primer as a primer layer. For waterproofing foundations and other underground parts of the building: apply 2-3 layers on a dry primed concrete surface, depending on the expected water load. To restore and arrange a seamless waterproofing coating of roofs: apply at least 2 layers of emulsion on the prepared base. To increase the service life of the finished coating, a mineral crumb must be applied to the fresh finishing layer of the emulsion.
Application Notes / Restrictions:Store in tightly closed original packaging, inaccessible to children, protected from direct sunlight, from heat sources and open flames.
It can be transported by any type of transport. Work with IZOPLAST should be carried out in windless weather without precipitation at ambient temperatures from 5°C to 25°C.
When performing work, observe the safety rules when working with organic solvents, the use of effective ventilation and masks with an organic vapor absorber.
- In case of poisoning, provide the victim with fresh air, provide first aid, call a doctor.
- Do not use IZOPLAST B inside residential and public buildings, as well as in other premises intended for permanent residence and the presence of people. The material must not come into direct contact with food or drinking water.
- The product is flammable. Irritates eyes and skin. Vapours can cause feelings of drowsiness and dizziness. Do not inhale vapours. Avoid contact with skin and eyes. Use only in well-ventilated areas.
Composition - Water-based bitumen-rubber emulsion
Packing - 24 kg bucket
Drying time - ≤ 8 hours
The emulsion density is 0.985-1.015 g/cm3
Consumption (first layer) - 0.8-1.2 kg/m2
Consumption (the following layers) - 0.6-0.8 kg/m2
Water content - ≤ 0.5 %
Application temperature - from 5°C to 25°C
The ignition temperature is 200 °C
The remainder of the dry mass is 80 %
Why use bituminous mastic?
Izoplast B bitumen-rubber mastic is used:
- for waterproofing pipes, sewer wells, concrete rings, pumping stations
- for waterproofing concrete foundations – foundations, screeds, fences, columns and supports
- for waterproofing with high resistance to aggressive environment
- for the preservation and waterproofing of the roof.
How to apply bituminous mastic on the foundation?
To protect the foundation, it is necessary to clean and level the surface, since future waterproofing must be continuous. The presence of debris, technological seams, cracks, chips and bubbles is unacceptable: for this, concrete is covered with Izoplast R primer. After the preparatory work is completed, Izoplast B bitumen-rubber mastic is applied from the water pressure side in two layers perpendicular to each other.
Can bituminous mastic be used in winter?
It is possible in the operating temperature range, but there are nuances. Previously, Izoplast B bitumen-rubber mastic or Izoplast R primer should be kept for 24 hours at room temperature of 20 ° C. When applying, take into account the base temperature, the lower it is, the worse the mastic will fall. If necessary, warm up the base with a roofing warmer.
Can you vikoristovuvat mastic yak primer?
In fact, the Izoplast R primer is bitumen mastic with a large amount of solvent. Therefore, it is possible to dilute Izoplast B 1:1 bitumen-rubber mastic and use it as a primer. But in reality it is much easier and cheaper to buy a ready-made Izoplast R primer. This will help to get rid of unnecessary work and material consumption.
Is it possible to store an already opened bucket of mastic?
You can, but not for long. The viability time of Izoplast B bitumen-rubber mastic corresponds to the drying time. If bitumen-rubber mastic or primer remains in the bucket after use, close the bucket tightly with a lid. In this case, the mastic can be reused for 2-3 months.
What should be the temperature of the bituminous mastic?
Before using Izoplast B bitumen-rubber mastic, you need to bring it into the room and leave it inside a day. The temperature before using bitumen mastic should be at least 15 °.
Other products in the category
Useful articles
Мастика для фундамента - отличное решение. Идеально подошла для моего дома. Легко наносится, а расход минимальный. Уверен, что теперь дом будет в безопасности от влаги.
Эта мастика - просто находка! Заказал для фундамента дома. Расход экономичный, а качество оказалось действительно хорошим. Теперь уверен, что фундамент надежно защищен от влаги. Спасибо!
Приобрел мастику для обработки фундамента в частном доме. Эффективно справилась с водонепроницаемостью. Легко наносится, и расход действительно небольшой. Рекомендую всем, кто заботится о сохранности дома.
Купил эту мастику для фундамента своего дома. Расход действительно минимальный, хватило на всю площадь. Качество приятно удивило, теперь дом защищен от влаги. Очень доволен покупкой!