Waterproofing mix Teknomer 200, 20kg+5l TEKNO

Instruction manual:

Before applying the material, the surface should be cleaned of any types of oil, rust, detergents, dirt and other substances that prevent setting.
If there are cracks or other damages on the surface, they must be previously repaired with Teknorep repair solutions. Use Tekomer 200 3-4 days after surface repair.
You should also determine the water pressure. Teknomer 200 is resistant to positive water pressure. If the water pressure is negative, this waterproofing should not be used.
Each corner of the surface to be tiled should be treated with Teknomer pah bandi insulation tape.
Teknomer 200 should be applied to the surface with a brush or a spatula. Each next layer should be applied perpendicular to the previous one.
The layer is considered dried when it ceases to be imprinted on the fingers.
When applying waterproofing to the screed, it is necessary to use a waterproofing mesh between the layers.
To prepare the working solution, pour the liquid component B into a clean container, then slowly pour out the powdered component A. Using a low-speed mixer, knead the composition for 5 minutes until a homogeneous mass is obtained. Leave the resulting mixture for 3 minutes, then re-mix the mixture for 2 minutes.

Notes:

Do not apply the mixture on chipboard, MDF, plywood, PVC, wooden and metal surfaces.
After applying waterproofing, make sure that direct sunlight and precipitation do not fall on the surface, and also do not use the material at temperatures above 35 C and below 5 C.
3 days after applying waterproofing, tiles or ceramics should be laid or plaster or screed applied to protect against all kinds of damage, scratches and bumps.
Work should be carried out in compliance with safety and hygiene standards, using a mask and glasses.
The tools and equipment used must be washed immediately after use.