Product code: 100005425
Manufacture`s article: 0000m1332
Adhesive and repair two-component mixture Hydroflex 21 for sealing joints, 5 kg Arfen
Hydroflex - 21 epoxy adhesive has a consistency that is convenient for application, does not contain solvents and consists of epoxy resin and epoxy hardener. This epoxy adhesive has high adhesion, and it can be applied even on a wet surface. When using epoxy glue, no prior application of the primer is required. Also, this glue can be used for anchoring reinforcement outlets and bolts, mounting cranes and other guiding equipment to the base.
Expenditure:For gluing Hydroflex tape 1,7-2 kg of Hydroflex 21 glue per 1 m.
Hydroflex-21 is a solvent-free epoxy two-component adhesive. Designed for fixing deformation tapes.
Appointment:Fixes the deformation tape
- Fasteners of reinforcement outlets and bolts
- Installation of guide machines and cranes to the base
Advantages:High adhesion ability
- Chemical resistance
- Absence of solvents in the composition
- It is used for expansion joints of floors, walls, blind areas and terraces
- Waterproof and gas tightness
- Adaptation to wet surfaces
- A practical consistency for application
- Applied without primer
- Multi-colored components help to monitor whether the mixture is well mixed enough.
Type : 2-component polymer composition
Base : Epoxy
Color : Grey
Mixing A:Q : 3.75:1.25
Pressure strength : ~ 62 N /mm2
Tensile and bending strength : ~ 30 N/mm2
Module E : ~ 5000 N/mm2
Time of loss of fluidity (viability ) : About 30 minutes
Processing temperature and object temperature: Not lower than 8 °C with a relative humidity of not more than 80%
Best working temperature : 15-20°C
Initial polymerization : 24 hours
Mechanical. loads are acceptable : after 5 days
Chemical loads are acceptable : after 7 days
Storage : In a dry and warm place
Storage time: In tightly closed factory packages for 18 months at a temperature of at least 20 ° C
What to pay attention to when preparing a mixture?
1. The mixture is prepared immediately before use and should be used within 30 minutes.
2. Do not leave the mixture in the container for more than 5 minutes after the end of mixing.
3. During application, the temperature of the substrate and the environment should be within 5 - 30 °C.
The lifetime and processing time of artificial resins depends on the humidity of the base and the ambient temperature: at low temperatures, the lifetime of the finished composition increases, and on the contrary, high temperatures accelerate the reaction
What is the consumption of Hydroflex - 21?
Consumption: Hydroflex 21 - 1.6 kg / 1 sq.m. per 1 mm layer, the specified material consumption rate is designed for a flat surface and a temperature from 15 to 25 ° C. At lower base temperatures, the flow rate may increase and the curing time may increase.
Additional products
Other products in the category
External waterstop ND 320 PVC for expansion joints, blue, 20 lm, Sanpol Ukraine
Useful articles
