How to glue tiles on the floor
The choice in favor of tiled flooring is an appropriate solution for the bathroom, kitchen and hallway. The tile is durable, does not absorb moisture, is easily cleaned from a variety of contaminants and is resistant to even aggressive household chemicals. However, all these advantages of tiles can be experienced on your own experience only when the tile lining is made of high quality, in compliance with technology and using good tile glue. Today we will talk about the main nuances that should be taken into account when laying tiles on the floor using Teknofay C1T glue — one of the best materials in the modern construction market.
Advantages of glue Teknofay C1TThe adhesive has high adhesion and is optimally adapted for laying ceramic tiles with a water absorption coefficient of 3% or more on vertical and horizontal concrete surfaces, including on the floor in residential and public premises.
High thermal stability (-40 ° C - 80 ° C), low consumption (about 4 kg of dry mix per square meter) and sufficient time of the open layer (20 minutes) make this cement-based composition one of the best tile adhesives for ceramic cladding. The masters note that Teknofay C1T is easy to apply, does not roll off, and, subject to technology, provides high quality cladding.
What you need to know before gluing tiles on the floor If you are convinced of the quality of the purchased tiles and have chosen high-quality Teknofay C1T glue for gluing, it is worth knowing a few technological nuances that should be observed:
Without fail, the floor should be cleaned of any dirt, oils, dirt, and dust. Otherwise, the glue simply will not grasp, which means that you can not think about the durability of the lining.
All irregularities and cracks need to be repaired, and the plane should be made as smooth as possible, without differences. Tile laying masters agree that leveling the floor with tile glue during the cladding process is not the best option. To do this, use Teknorep cement repair mixes. If the floor plane is completely curved, it is worth pouring a new screed.
It is possible to proceed to laying tiles after repairing the surface only 4 days after the repair.
Previously, before laying the tiles, the concrete floor was slightly moistened with water, but modern technologies involve applying a primer.
When all the preparatory work is completed, knead the glue, following the instructions.
- Installation work should be carried out in the ambient temperature range from 5 ° C to 35 ° C. If the temperature is lower or higher, prepare a thermal insulation material with which you will cover the fresh lining. This will allow the glue to dry normally.
- The tile floor can be put into operation no earlier than 24 hours after the completion of the work. After this time, you can start grouting the seams.
Follow these recommendations when laying tiles with Teknofay C1T glue, and the tile floor will serve a long and good service.
