Tile adhesive for walls
Facing works performed on vertical surfaces require the use of a special tile adhesive, because the solution must have a high resistance to rolling. Otherwise, even the most expensive ceramic tile simply will not hold on the wall normally. It is also possible that irregularities and mechanical damage to the tile may occur. Today we will consider in detail the adhesive for ceramic tiles and granite Teknofay EX C2TE, which is optimally adapted for facing vertical surfaces, as well as stipulate its advantages and method of operation.
What is Teknofay EX C2TEThis adhesive solution has high adhesion, as well as resistance to sliding < 0.5 mm.
These characteristics allow the use of Teknofay EX C2TE glue for wall cladding using ceramic tiles, porcelain, granite, natural stone of white color inside and outside the premises.
The glue is a dry mixture, which is supplied in bags of 25 kg. For mixing, clean water is often used in an amount of 6.8-7.2 liters per bag of dry mix.
What are the advantages of Teknofay EX C2TE glueResistance to sliding ensures high quality of facing work on vertical surfaces.
- Suitable for gluing tiles with a water absorption coefficient of more than 3%.
- The composition is waterproof, which means it is widely used for cladding work in rooms with high humidity: saunas, baths, hammam, swimming pools.
- Suitable for cladding inside and outside buildings.
- Suitable for the arrangement of loggias, open balconies and other similar structures.
- Resistance to temperature effects in the range from -40 ° C to 80 ° C allows you to use this adhesive during cladding work in heated pools, put tiles on a warm floor, as well as equip walls and floors in industrial freezers.
- The time of the open layer is 30 minutes, which makes the adhesive composition convenient to work with.
How to use Teknofay EX C2TE glueThe required amount of dry mixture is diluted with water in accordance with the instructions.
Previously, the wall (or floor) is leveled, if necessary, repaired with special cement repair mixes. It is recommended to moisten concrete walls before starting work.
It is necessary to lay the tile with Teknofay EX C2TE glue at an ambient temperature of 5 to 35 ° C. If the temperature is higher or lower than the required indicator, after the work, the lining is covered with thermal insulation. Grouting of seams is possible 24 hours after the completion of the work.
