Teknoself 500 concrete flooring mortar, thin-layer, non-shrinking, high strength, 25 kg TEKNO

1 200

uah / bag

Teknoself 500 is a reinforced self–leveling solution for self-leveling floors with synthetic polymer additives and increased adhesive strength.

Applications:

It is used as a leveling screed to prepare the surface for tiles, ceramics, granite, marble, parquet, linoleum, carpet.
For indoor and outdoor use.
To create surfaces with increased resistance to loads (shops, exhibition areas, industrial sites).
For areas where it is necessary to pour a self-leveling coating with a thickness of less than 10 mm.

Features and Benefits:

Easy to apply.
It cures quickly, the surface is ready for pedestrian loads in 2 hours, full cure in 15 hours.
It has high adhesion.
Makes the surface perfectly smooth.
Does not crack.

Instructions for use:

Before applying, clean the surface from any types of oil, rust, detergents and other substances that prevent setting. If there are areas in the form of cracks, cavities on the surface - they should be repaired with the help of convenient cement mixtures Teknorep 300 or Teknorep 300EX. For better adhesion, the prepared surface must be treated with a TEKNOLATEX 500 or TEKNOLATEX 300 primer, depending on its structure. Dry surfaces should be slightly moistened. TEKNOSELF should be applied after 3-4 days.

Distribute the prepared material evenly over the primed surface. Before applying, we recommend removing air bubbles with a needle roller. The solution should be kneaded using a low-speed electric mixer (maximum 400 revolutions per minute) until a homogeneous mass is obtained. Gradually add the powder material to a container with 5 - 6 liters of water and continue mixing until a homogeneous mixture is obtained. The amount of water to mix may vary depending on the ambient temperature. The solution should be used and spread on the surface for 30 minutes.

Warnings for use:

After application, it is necessary to protect the surface from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (more than +35 °C), rain and frost.
The floor temperature should not fall below +10 °C during curing.
It is necessary to protect the floor from contact with water after applying the solution.
The tools and equipment used must be washed with warm water immediately after use.

Colour	Gray
Expiration date	12 months in a dry environment in a closed package.
Packaging	25 kg bag
Particle diameter	≤ 0.3 mm
Application temperature	+5 °C...+35 °C
Mixing ratio	5-6 liters of water/25 kg of powder
Life time of the mixture	20-30 minutes
The density of the solution	1.8±0.1 kg/l
Expenditure	1.8 kg/m² (with a layer thickness of 1 mm)
Thickness of application	3-30 mm
Flexural strength (28 days)	≥ 5.0 N/mm²
Compressive strength (28 days)	≥ 25.0 N/mm² (TS EN 196-1)

How to level the concrete floor in the garage?

During operation, the garage floor covering is subjected to loads and gradually collapses. To level and restore the concrete floor in the garage, you can use a reinforced self-leveling self-leveling mixture Teknoself 500, the thickness of its application is from 3 to 30 mm. It cures quickly, the surface is ready for pedestrian loads in 2 hours.

How to remove the rake on the screed?

In order to level the slope on a concrete base, it is best to use a self-leveling self-leveling mixture Teknoself 500. The material is used for areas where it is necessary to pour a self-leveling coating with a thickness of 3 to 30 mm.

How to level a concrete floor with a thin layer?

For areas where it is necessary to pour a self-leveling coating with a thickness of less than 10 mm, it is best to use a reinforced thin-layer self-leveling mixture Teknoself 500 with synthetic polymer additives and increased adhesive strength. The thickness of its application is from 3 to 30 mm, it does not crack even with a minimum thickness of application.

How to update old concrete in the yard?

There are often situations that damage appears on the old concrete in the yard. To restore the concrete coating in the yard, you can use a reinforced self-leveling self-leveling mixture Teknoself 500, the thickness of its application is from 3 to 30 mm. It cures quickly, the surface is ready for pedestrian loading in 2 hours.

Unfortunately there are no reviews yet. But you can fix it!