Two-component liquid waterproofing membrane Waterstop 2K, gray, 12 kg Admix

4 980

uah / canister

Cold-applied and cold-cured material. Solvent-free. It has an elastic structure, resistant to UV and abrasion. It is applied to surfaces such as concrete, metal, wooden surfaces (in combination with an appropriate primer).

Application:

Concrete tanks, including tanks with drinking water
Reservoirs, underground water structures
Areas with constant exposure to water
Foundations bearing walls
Fuel-affected areas
Terraces and balconies
"Light" roofs made of metal or fibrolite
Floors with heavy pedestrian load
Floors of semi-intensive loading of transport

Advantages:

Elastic structure
Self-leveling material
Excellent adhesive properties
Resistant to constant exposure to water and frost
Retains its physical properties in the temperature range from – 30ºC to 90ºC
Resistant to UV and color fading
Resistant to chemicals (solvents, oils, sea water, weak acids and sulfates)
Vapor permeable, allowing the surface to "breathe"
Does not contain solvents
May come into contact with drinking water
After drying, it does not contain toxic substances
Can be used indoors
Cold-applied material. It is applied using a roller, brush or airless spray device.

Instructions for use:

Surface preparation:

The surface to be applied must be dry and clean, without damage, traces of oil, paraffin, grease, etc. Surface defects, such as cracks, should be eliminated using suitable products. ADMIX WATERSTOP 2K is applied to a pre-primed surface.

Concrete base requirements (standard):

Hardness R28 – 15 MPa
Temperature — +5°C-+35 °C
Relative humidity — <85 %

Preparation of the material:

To obtain a homogeneous mass, the temperature of the material should not be below 15°C. Mix component A with a mixer, then gradually pour in the hardener (Component B) according to the mixing proportions. Mix the resulting mixture for 3 minutes using a low-speed mixer until smooth.

Application:

ADMIX WATERSTOP 2K is applied using a roller, brush or airless spray device.
The time between layers should be at least 4 and a maximum of 24 hours (at an air temperature of 23°C). If the interlayer time is exceeded, the surface should be sanded. Try not to exceed the time of interlayer application.
The material acquires full mechanical and chemical properties after 7 days (at an air temperature of 23°C and a relative humidity of 55%).
Do not allow bubbles to appear during the application of the material. If they occur, remove the bubbles with a needle roller.
Place the container with the material in a warm room (room temperature) 24 hours before application.
Mix the material only with a low-speed mixer.
ADMIX WATERSTOP is completely ready for use and does not require dilution.
After applying the material and before it dries, the surface must be protected from rain, water, frost, mechanical impact, etc.
The time of interlayer application is 4-24 hours. Please note that the time may increase in cold weather and decrease in warm weather.

Packaging:

Component A — 10 kg, Component B — 2 kg

(23ºC,rel.humidity 55%)

Appearance:
Component A: Waterstop

Component B: Hardener : White, gray, green, blue, all RAL colorsMixing proportions:

Comp.A : Comp. B - 5 : 1The density of the finished mixture, g/cm3, ASTM D1425 / DIN 53217 / ISO 2811 - 1.40 ± 0.05

Dry residue^% - ~100

Working time, minutes - 35 - 40

Readiness for light pedestrian loads, hours - 8 - 12

Operating temperature, °C, 5ºC - 35ºC

Rigidity, Shore A - ASTM D2240/ DIN 53505/ ISO R868 - 80