Waterstop PO-3 PVC external repair for seams, grey, 20 lm, Sanpol Ukraine Sanpol

11 440

uah / roll.

Repair hydroshpons of the PO-3 series are used for waterproofing expansion joints when mating with existing concrete structures. It is used in the monolithic construction of buildings, including foundations, underground parking lots, tunnels, canals, etc. The repair hydraulic shingle is fixed to the existing concrete structure, the free part of the hydraulic shingle is loosened to the reinforcement frame of the poured structure, immediately before pouring concrete. They are designed to seal the expansion joints between the finished w/ b structure and the poured structure. The absence of fastening anchors on one side of the hydraulic shroud, allow you to hermetically glue the U-shaped hydraulic shroud to the finished w / b structure. For reliable fixation of the hydraulic pin, a metal strip is used, which is fixed from the inside of the hydraulic pin with dowels. The U-shaped shape allows you to clearly install the hydroshaper in the design position using an elastic sheet material, for example, a styrofoam plate, on which the hydroshaper is "put on". The presence of ribs on the locking plane prevents the penetration of moisture into the structure.

it is used in the locations of deformation joints of monolithic reinforced concrete structures
in particularly important structures, it is supplemented with an internal or external repair hydraulic shponka
they are delivered in bays of 25 m.p.
If it is necessary to lengthen and to perform spatial nodal transitions, they are welded in a conductor, with a construction hairdryer, a flat TEN-om or glued together

U-shaped hydrosponk Sanpol series BYIt is used for sealing and waterproofing movable joints in monolithic construction of buried and underground structures when coupled with existing concrete structures.

The U-shaped shape of the hydraulic key allows you to clearly install the key in the design position, using, for example, a sheet of expanded polystyrene, on which the key is "put on".

The presence of ribs on the locking plane prevents the penetration of moisture into the structure.

Advantages of using hydroshpons:

it is used in the locations of deformation joints of monolithic reinforced concrete structures when mating with an existing concrete structure, in particularly important structures it is supplemented with an internal or lower external hydraulic gasket;
withstands small water pressure inside and outside;

Material : Plasticized polyvinyl chloride (PVC-p)

Color : Grey

Packaging : Rolls of 25 m.p.

Shore Hardness : A 70 ± 5 7

Density, g/cm3 ≈ 1.48

Tensile strength, MPa ≥10 (DIN 53455)

Elongation at break, % ≥ 275

Temperature resistance, °C from -35°C to 70°C 11

Chemical resistance:

- constant exposure to water and wastewater, benzenes and oils;

- from short-term exposure to inorganic alkalis and acids of low and medium concentration.

- from constant exposure to water and wastewater;