Reinforcement retainer Star protective layer 35 mm, 250 pcs. Sanpol

Retainers for reinforcement – allow you to achieve maximum strength and reliability of the supporting frame, contribute to pouring the exact thickness of the protective concrete layer between the formwork panels and the reinforcement mesh. The clamps allow you to place the reinforcement at the right distance from the base and the walls of the formwork. The height of the clamps is selected based on 1/3 of the height of the protective layer.

The protective layer of concrete is the distance from the outer face of the reinforced concrete element to the nearest reinforcing bar. The thickness of the protective layer of concrete should be selected, taking into account the purpose of reinforcement in structures. The working or constructive role of the reinforcement is taken into account; the type of structure (for example, a column, slab, beam, foundation element or wall); the diameter and type of reinforcement. This is due to the fact that too thin a layer will not fully perform its functions, and too thick a layer will negatively affect the reinforced frame and lead to increased costs.

The parameters of the protective layer are clearly regulated by the norms:

• at standard or low humidity in the room, the thickness of the protective layer of concrete should not be less than 20 mm.
• with high humidity inside the structures, the thickness of concrete should be at least 25 mm.
• during the construction of buildings, the reinforced concrete parts of which go out into the open atmosphere, the protective layer of concrete should be 30 – 40 mm.
• for floors up to 250 mm thick, the concrete layer must be at least 12 mm. This value varies depending on the diameter of the valve. For overlaps of greater thickness, the thickness of the formation increases by 5 mm;
• the part of the structure placed in the ground without the use of additional protection should be covered with a layer of concrete from 40 to 76 mm.
• for foundations, a layer thickness of at least 40 mm is provided.

For the vertical monoliths, there are "zirochka" laboratories.  The armature fixator "Zirochka" is allowed to set the frame of the formwork to the reinforcement frame. Roztashovuyut fiksatori in the chess order on a distance of 40-50 cm one by one.