Adhesive for aerated concrete blocks Teknofay 500, 25 kg TEKNO

Surface preparation: Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting. When laying aerated concrete blocks on a concrete surface, it should be slightly moistened.

Preparation of the mixture: 

1. Pour 6.5 – 8.5 liters of clean water into a clean container and pour the Teknofay 500 (25 kg) dry mixture into a container with water and use a low-speed mixer to knead the mixture for at least 5 minutes until a homogeneous mass is obtained.
2. Leave the resulting mixture for 3 minutes, then re-mix it with a mixer for 2 minutes.
3. The masonry mortar should be applied to the brick with a notched trowel on the bottom row of the finished masonry and on the lateral vertical plane of the brick.
4. To press the brick when adjusting to the level, it is recommended to use a rubber hammer, in this case the surface of the block will not be damaged.
5. Within 5 minutes, you should lay out and fix the material on the surface.
6. If 5 minutes have passed, it is necessary to scrape the solution from the surface and throw it away, then apply a new layer of solution.
7. When laying, it is necessary to remember the rules of bricklaying (as well as when laying blocks), and also do not forget to lay metal or fiberglass reinforcement after each 4th row.

Note: 

• The work should be carried out at an air temperature from +5°C to +35 ° C.
• When laying tiles at a lowered (below +5°C) or elevated (above +35°C) temperature, it is necessary to cover freshly laid bricks or aerated concrete blocks with thermal insulation material.
• After applying the mixture, it is necessary to protect the surface from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (more than +35°C), rain and frost.
• The tools and equipment used should be washed with warm water immediately after use. You should also wash your hands thoroughly.

Security measures: The product may cause irritation if it gets on the skin. It is necessary to use work clothes, protective gloves, a mask and glasses. Before starting work, you can apply a protective cream on your hands. In case of contact with the eyes, rinse the eyes immediately with warm water and consult a doctor.

Storage: Store in a dry, frost-proof place, in an intact original packaging for no more than 12 months from the date of manufacture.