Thixotropic adhesive for ceramic tiles Teknofay EX C2TE high strength, white, 25 kg TEKNO

396

uah / bag

Teknofay EX C2TE adhesive solution with increased adhesion strength for porcelain, ceramics, granite, marble, etc.

Where it is used:

It is used on vertical and horizontal surfaces
It is applied outside and inside
In residential buildings, shopping malls, hospitals
For gluing materials with low adhesion, such as small and medium-sized tiles, ceramics with a degree of water absorption of more than 3%.
For glued materials such as granite ceramics, marble and natural granite
On terraces and balconies
For gluing to thermal insulation boards and slabs made of pumice or aerated concrete
For application on gypsum plaster, drywall, aerated concrete and open concrete.
In places with high humidity such as, swimming pool, bathroom, shower room, etc.
It is used for gluing ceramics and granite on exterior facades
On heated floors, in heated pools, in thermal pools, freezers.

Features and Benefits:

Easy to prepare and apply
It has high adhesive properties
Does not slip in an upright position
Saves time and labor
Waterproof

Instructions for use:

Pour 6,8-7,2 liters of clean, transparent water into a clean container, in which there are no all kinds of materials that prevent adhesion. After that, slowly pour into a container filled with water. Mix the material with a low-speed mixer until a homogeneous mixture without lumps is obtained. The mixture obtained as a result of mixing should be left alone for 5-10 minutes and stir it again for 2 minutes until it becomes homogeneous.

Application Notes/Restrictions:

The product may irritate the skin. When working with the material, it is necessary to use work clothes, protective gloves, a mask and glasses.
The prepared solution is applied to the surface with a toothed spatula with the appropriate size of the teeth.
The tile is laid on the glue and pressed no later than 10 minutes after its application.
The position of the tile can be adjusted within about 15 minutes after laying.
In case of contact with the adhesive solution in the eyes, rinse immediately with warm water and consult a doctor.
It is recommended to fill the facing seams with grout no earlier than 24 hours after laying the tile.
The work should be carried out in dry conditions, at air and base temperatures from +5°C to +30°C and relative humidity not higher than 80%.

The name of the indicator	Normative value
Appearance	White powder
Storage in a dry dark warehouse, subject to the temperature range of +5...+35 ° C, humidity not higher than 80%	12 months
Packaging	25 kg bag
Temperature range of application, °C	+5…+35°C
Mixing proportions	6.0 - 7.0 water/25 kg powder
Life time of the mixture	6 hours
Operating temperature range	-40°C...+80°C
Resistance to sliding	≤ 0.5 mm
The beginning of mechanical loads	1 day - on the floor, 8 hours - on the wall
Adhesive joint strength:

After exposure in a dry environment	≥ 1.0 N/mm²
After exposure in a wet environment	≥ 1.0 N/mm²
After exposure in a hot environment	≥ 1.0 N/mm²
After cyclic freezing and thawing	≥ 1.0 N/mm²
Fire reaction class	A1