Chemical anchor Teknobond 401 W, epoxy, 410 ml TEKNO

Application Instructions:

• The surface for application must be cleaned of dust, dirt, loose particles, cement mortar residues, oils and fats.
• The concrete base must be clean, strong and have sufficient compressive strength.
• The application surface should be cleaned using compressed air to maintain maximum adhesion strength.
• The surface and ambient temperature should be + 5°C...+ 35°C.

To open the lid, turn it. Then install a static mixer. Place the cartridge in the gun and proceed with the application. When the application process is stopped, the tip of the static mixer can be left on the cartridge after the pressure in the sprayer is released. If the resin has hardened in the static mixer, a new insert must be installed before starting work. When storing an open cartridge, remove the static mixer by turning it, wipe the cartridge neck with a clean, dry cloth and close the lid.

Application method: Drill a hole of the required diameter and depth using a punch. The diameter and depth of the hole must correspond to the size of the anchor element used. The hole should be cleaned from the inside with a round wire brush and compressed air. Then hold the trigger until the two separate cartridge components exit the static mixer. Slowly pull out the cartridge, filling the hole with resin, starting from the bottom of the hole. Make sure there are no air gaps inside.

An extension cord can be used in deep holes. Rotate the anchor when inserting it. The anchor element should be placed in the hole during the gelling period of the resin. During quenching, in no case should the anchor element be moved or loaded. During application, work clothes, glasses and protective seals should be used. The components of the material should not come into contact with the skin and eyes, and in case of contact, they should be immediately washed with plenty of soap and water.