Adhesive for ceramic tiles Teknofay Plus-C1TE one-component, white, 25 kg TEKNO

Instructions for use

Surface preparation:

The application surface must be cleaned of materials that prevent adhesion, such as dust, oil, resins and detergent. Weak parts of the surface should be dismantled. Chips, potholes and pits on the surface should be repaired with the help of appropriate Teknorep repair compounds. Before starting work, the surface should be cleaned with compressed air.

Mixing of the adhesive solution:
To mix the adhesive solution, it is necessary to add a dry mixture to clean water (in the proportion of 1 kg of the mixture per 1 liter of water). Mixing is carried out using an electric mixer at low speeds (500-600 rpm) for 3 minutes. Let the solution stand for 5 minutes, then mix again until smooth.   

Application and gluing:

Apply glue to the tile with the flat part of the spatula, and then hold the toothed side in one direction over it, then press it tightly to the gluing surface. The contact area of the tile with the surface must be at least 80%.

Gluing and leveling of ceramic tiles must be carried out within 30 minutes after applying the glue.

Notes/restrictions on use:

• Do not add foreign substances to the mixture.
• For better adhesion of the glue to the surface, it is necessary to make notches on it
• May cause irritation if it gets on the skin.
• The equipment used should be washed with warm water and detergent immediately after application. After the glue has fully cured, cleaning of the equipment will be possible only by mechanical means.
• When working with the material, use basic protective equipment – gloves, goggles, protective masks. In case of contact with the eyes, rinse immediately with warm water and consult a doctor
• After application, the surface must be protected from direct sunlight, precipitation, negative and high ambient temperatures (below +5°C and above +35°C).