Rebar clamps
The fittings are installed before pouring concrete on the reinforcement, but it is not allowed to remove the reinforcement on the concrete base of the formwork. The fittings of the vikorist are designed for the baking of a large number of concrete structures on this armoured concrete.
It is significant that, unfortunately, the process of concreting, fixing for reinforcement is exaggerated by the fact that the reinforcement frame is not laid down. Therefore, it is allowed to take care of the necessary goods from the bottom of the bowl, to prevent the passage of rubber fittings on the surface of that strip of corrosion of the fittings.
Fittings are poured into concrete, which is an inexpensive home-made material, due to the need for secondary repairs. Ale, Sirovina has been reborn in the eyes of the doctors, who are trying to get a little bit of a victory. The joints of the pipe fittings are not sharpened to corrosion, they are visible temperature differences, they are sharp to high and low temperatures, they are not deformable.
If there is a device for fittings with a diameter from 8 to 16 millimeters, then there is a smaller armature diameter, which is more expensive. For high-quality fittings, it is recommended to increase the pressure from 5 to 10 points per square meter.
There are a few basic types of specifications:
- Fixator – a hole in the armament of vertical concrete structures
- The fixator is a device for horizontal expansion of fittings at the installation of foundations, promislovyh logs, plates perekrittiv on the base
- Fixator – flooring for horizontal expansion of reinforcement when pouring concrete poured logs on crushed stone and non–solid surfaces - gypsum, polystyrene, cotton wool
- Fixator – cone for sealing the concrete through the middle of the tube
- The fixator is a zigzag bar with an armoured recrittation and a prepared deposit of concrete slabs, for fixing fittings, reinforcing bars with a round ball with a width of 15 to 25 mm
- The radiator is a piece of concrete for the installation of vertical and horizontal fittings for the construction of dams, a ridge, a tunnel for hydroelectric power plants, canals, reservoirs for the largest hydrotechnical structures, tunnels for the underground railway.
